Processings Automatic machines

PLUS

THE LAST GENERATION MACHINES ARE CAPABLE OF INCREASING THE QUALITY STANDARDS OF PRODUCTS, REDUCING THE ENVIRONMENTAL IMPACT.

CUT ON DISC

PHASE 1.
EASY AIR, in all its varieties, can also be cut using diamond discs. The discs must be for porcelain gres and in good conditions. It is recommended to proceed with high rotation speeds (> 2000 rpm) and feed speed between 0.5 and 1 m / min. Depending on the type of disc and on the length of the cut it may be necessary to water-cool the disc itself. It is also recommended to reduce the rotation speed when the tool enters and exits the slab.


ZOOM

FETTLE STEEL WITH GRINDER


ZOOM

CUTTING WITH WATER-JET MACHINE

EASY AIR, in all its varieties, can also be cut using water-jet machines. We recommend using an operation speed between 2 and 3 m / min.


ZOOM

DRILL WITH NUMERIC CONTROL MACHINE EASY AIR

EASY AIR, in all its varieties, can be drilled using numeric control machines. A preliminary hole must be made using a diamond point, then, if necessary, use a milling machine to enlarge the hole to the required dimensions. Use a bit with a diameter between 4 and 8 mm. The operating speed is 40 mm / min, with a mandrel rotation of 900 rpm.


ZOOM

DRILLING WITH WATER-JET MACHINE

EASY AIR, in all its varieties, can also be drilled using water-jet machines. Water-jet allows making holes with a smaller diameter than those that can be realized with numeric control machines. The operating speed must be between 2 and 3 m / min.


ZOOM

45 ° DRILLING AND STEEL FETTLING

To make a 45 ° cut, you can use 45 ° inclined diamond discs. In this way it is possible to create a corner with two slabs of EASY AIR, in all its varieties. The new edge must then be softened. Numerous types of edge finishing can be obtained using different wheels. The operating speed must be previously tested.


ZOOM